Live Chat Available|
|
ARCHIVED
The MAC7100 Standard Evaluation Board is a full-featured design kit that enables evaluation and prototyping with the MAC7100 family of MCUs. JTAG and Nexus Class 2 interfaces provide powerful debugging capability. Take advantage of the prototyping area with access to power and ground. Stay connected with on-board Ethernet and CAN networking support. The evaluation board includes a MAC7111 microcontroller as well as 128K SRAM and 2MB of external Flash on-board. Two expansion connectors allow access to the MCU's external bus
Archived content is no longer updated and is made available for historical reference only.
View Product ImageFeatures
- MAC7111 MCU device soldered directly onto the EVB
- 128K Bytes of asynchronous SRAM and 2M Bytes of asynchronous FLASH soldered to the EVB
- Single external power supply input, regulated on board to provide all the necessary EVB voltages
- Master power switch
- User Reset and Abort pushbutton switches
- Configurable Low Voltage Inhibit (LVI) control circuitry to monitor all of the voltages from the EVB regulators
- Full reset mode configuration switches
- User-configurable MCU clock source ( using on-board crystal, on-board oscillator, orexternal clock source)
- 14- and 20-way JTAG connectors
- 38-pin MICTOR (Matched Impedance Connector) NEXUS connectors
- Two 120-way expansion connectors to allow connection of daughter cards
- Array of user connectors, providing direct access to all of the MCU port signals
- Large, accessable through-hole prototyping grid
- Two SCI (RS232) physical interface circuits allow direct connection to a PC
- Two High Speed CAN interface transcievers
- Full Duplex 10/100Mb Ethernet controller with RJ45 connector
Increase Your Knowledge
- Design News Update Subscribe for design tips, tricks and product news delivered to your inbox.
- On-Demand Training Learn from the experts at your convenience.
