The Evaluation kit supports the 33812, which is an engine control analog power IC intended for motorcycle and other single/dual cylinder small engine control applications. The IC consists of three integrated low side drivers, one pre-driver, a +5.0 V, voltage pre-regulator, an MCU watchdog circuit, an ISO 9141 K-Line interface, and a parallel interface for MCU communication. The three low side drivers are provided for driving a fuel injector, a lamp or LED, and a relay or other load. The pre-driver is intended to drive either an Insulated Gate Bipolar Transistor (IGBT) or a bipolar Darlington transistor to control an ignition coil.
Features
- Designed to operate over the range of ~4.7 V ≤ VPWR ≤ 36 V
- Fuel Injector driver - Current Limit - 4.0 A Typical
- Ignition pre-driver can drive IGBT or Darlington bipolar junction transistors
- Ignition pre-driver has independent high and low side outputs
- Relay driver - Current Limit - 4.0 A Typical
- Lamp driver- Current Limit - 1.5 A Typical
- All external outputs protected against short to battery, over-current
- Ignition and other drivers protected against over-temperature
- Interfaces directly to MCU using 5.0 V parallel interface
- VCC voltage pre-regulator provides +5.0 V power for the MCU
- MCU Power On RESET generator
- MCU watchdog timer circuit with parallel refresh/time setting line
- Independent fault annunciation outputs for ignition and injection
- ISO-9141 K-Line transceiver for communicating diagnostic messages
Featured Documentation
Kit Contains
- Assembled and tested evaluation board/module in anti-static bag.
- Misc Cables (see packing list)
- CD-ROM containing:
- Supporting Documentation for featured device (may include datasheet, user's guides, app notes...etc)
- Schematic of evaluation board
- Bill-of-Material for evaluation board
- Instruction sheet for evaluation board
- Software and configuration files (if applicable)
Get Started
Download User Guide
Contains BOM, set-up instructions, equipment list, schematic,etc.
Download Gerber Files
Contains drill files, pcb layers/layout, silk screens, etc.
